Router Bits for Hardwood: Surfacing and Lock Miters

Compare two SpeTool hardwood surfacing bits and the MNA lock-miter set. Match the cutter’s purpose, shank, and setup to the work.

2 min read

Benzafind may earn a commission from purchases through affiliate links, at no additional cost to you.

We may earn a commission from qualifying Amazon purchases. This comparison uses saved product listings.

Compare router bits for hardwood by the cut you need. Two SpeTool cutters are listed for surfacing slabs or spoilboards. MNA’s set is for shaping an interlocking corner joint. The jobs are different, even when two products share a 1/4-inch shank.

Comparison at a glance

Model and ASINListed jobShank and cutting geometry
SpeTool IP3F-2-D1/2-ATS
B0C1TVQ71S
Slab or spoilboard surfacing1/2-inch shank; 2-inch diameter; three-wing insert design
SpeTool W05004
B0C6XMCXD3
Slab or spoilboard surfacing1/4-inch shank; 1-1/4-inch diameter; 2+2 design
MNA JS-03A4
B092CJW3TR
Lock-miter joinery1/4-inch shank; three bits for listed stock heights

SpeTool IP3F-2-D1/2-ATS

SpeTool IP3F-2-D1/2-ATS listing photo

The 2-inch SpeTool IP3F-2-D1/2-ATS covers a wider strip per pass than the W05004, which can be useful on a broad slab when the router, sled opening and collet all accommodate it. That comparison is about cutter width; it does not establish a feed rate or quality of finish. Check: On Amazon, verify the IP3F-2-D1/2-ATS operating limits and exact 12 × 12 × 2.2 mm insert type before buying spares.

View on Amazon

SpeTool W05004

SpeTool W05004 listing photo

The SpeTool W05004 gives you a surfacing option for a compatible 1/4-inch collet. Its 1-1/4-inch diameter covers a narrower strip per pass than the 2-inch SpeTool, so expect more overlapping passes to cover the same width under comparable setup. Check: On Amazon, confirm cutter clearance and the W05004’s 10 × 10 × 2.2 mm replacement insert type; those dimensions differ from the larger cutter’s inserts.

View on Amazon

MNA JS-03A4

MNA JS-03A4 listing photo

The MNA JS-03A4 shapes mating edges for an interlocking 90-degree corner. The three listed cutting heights let you choose a profile for the stock at hand, provided the actual stock thickness and router-table setup suit the bit. Check: On Amazon, compare the JS-03A4 instructions with your measured stock thickness and table setup before ordering.

View on Amazon

Which option fits your needs?

Select the operation first, then check the actual shank, cutter clearance and stock requirements against the relevant manuals. For surfacing, compare the two SpeTool cutter widths and the replacement inserts you will need. For lock miters, focus on stock height and compatible router-table setup.